OPERATION (‘HL’ Model) 12B
not seated on the stops or the scissors not completely lowered. In
this way once you are used to the controls, the speed at which the
skip will tip or the scissors raised or lowered can be finely controlled.
Once the skip is empty pull the outer lever to the rear and allow the
skip to return down on to the skip stops. Move the inner lever to the
rear and lower the scissors to the rest position.
Do NOT allow the skip or scissors to return onto the stops or rest
position with any force, control the speed of their return using the
operating lever and gently bring the skip back onto to stops or lower
the scissors to the rest position. This is particularly important if you
have not completely emptied the skip.
Allowing the skip or scissors to return onto the stops or rest position
with force will damage the machine.
Holding the lever to the rear until the skip or scissors are fully
lowered will cause the relief valve located in the control valve to
‘blow off’ allowing the oil to return to tank. Do not continue to hold
the lever rearward when the ‘relief valve’ blows off, this will cause the
hydraulic oil temperature to increase and may cause damage to
components. Once the skip is seated on the stops or the scissors are
lowered to the rest position release the operating lever to the neutral
position.
To Next Page
Loading...
