Winix L500 - Programmable Humidistat; LightCel (UV+)

L500
|
5
English
English
05. Programmable Humidistat
•
The default humidistat setting is CO. (continuous) The
programmable humidistat can be set in 5% increments,
from 40% to 60% humidity.
•
Manual humidity is set in 40% > 45% > 50% > 55% > 60%
> CO order.
NOTE: When the set humidity level is reached, the
humidifier will cycle off until the humidity in the room
drops 5% below the set humidity level, then will cycle on
until the set humidity level is reached again.
06. Adjustable Mist Level
•
Mistadjustsfromthelowestoutputtothehighest
output.
•
The corresponding mist level will be lit on the display.
Each press will increase by one.
•
Once you reach level 5, it will repeat at level 1.
07. LightCel™ (UV+)
•
Displays the operation status of the UV-C LED that
sterilizes the flow path of the reservoir.
•
Power of the product is activated and turned off when
no water is detected.
NOTE: LightCel
TM
Technology Removes bacteria*
present in water, Ensuring a safe and sanitized mist for
you and your family.
(*Based on independent laboratory test conducted on
Escherichia coil, Staphylococcus aureus, Salmonella
typhimurium,Klebsiellapneumoniae)
08. Warm Light
•
If you select warm humidification, it turns on.
09. Timer/Display Light
•
When a time reservation is set, it turns on and displays
the time on the display.
10. Empty Tank Alarm
•
If there is not enough water, the unit will stop and the
red LED indicator will continue to blink at the same
time.
11. Mist Level Indicator
•
Displays the humidity level and goes up one step each
time the humidity level button is pressed.