1. Remove all parts from packaging and carefully remove pipe plugs
without damaging the pipe openings.
2. Begin by gathering parts (A)-(M).
3. Ensure you have enough room to begin the assembly (10 ft x 5 ft)
4. Begin the assembly from the base and work your way to the top.
5. Refer to diagram for instruction
(*Note: Connections may t snug so if necessary use a rubber mallet)
Instructions to Build:
4’x 6’ Steel Hockey Goal
-Page 2-
Attaching the QuikNet Mesh
PART NO. SKETCH QTY
N
1
1. Gather part (N)
2. Begin fastening the netting to the goal using the Velcro straps
at the top of the goal and continue all the way around the net.
(Refer to diagram below for Velcro procedure)
(i) Open Velcro tab (ii) Slip tab through
“Roadez” wire weld
(iii) Close Velcro tab
*Note: The QuikNet mesh has 3
coloured tabs. The two red tabs
line up with the front post at parts
(E) and (F) and the green tabs sits
at the midpoint of part (D)
PART NO. SKETCH QTY
A
C
B
D
E
F
G
H
J
K
I
1
1
2
1
1
1
1
1
1
1
1
1
1
E L F
BA
D
K
C C
G H
J
I
M
Red Tab
lines up here
Red Tab
lines up here
Green Tab
lines up here
L
M
To Next Page
Loading...