Instructions to Build:
The Backstop (Top) & Pocket Target
PART NO. SKETCH QTY
1
1
10
1. Begin by gathering part (15).
2. Ensure that the thick strap on the netting is at the top when
you begin assembly.
3. Secure the top straps of the netting to the wire weld on the inside
corner of the frames using the white 1’ string provided.
4. Next you can secure the bottom corners of the top net to the steel
loops on the side panels using the 1’ string provided.
5. Now you need to secure the sides of the netting to the panels.
6. Use the 14’ strings provided to lace the netting to the side panels and
goal. (See gure below)
-Page 4-
Attaching the Pocket Target
1. Begin by gathering part (16) - (17)
2. Start by fastening the top corner of the target to goal using the
Velcro straps provided
Note: 3 Velcro straps are used for the top corners and 2 are used
for each of the bottom two locations.
(Refer to the diagram to the left for placement instruction).
15
16
17
NOTE: 2 of the 14’ Strings are
required to fasten the top net
to the goal and side stops
(See diagram to left)
14’ String
Velcro Strap
To Previous Page
Loading...