Wintex Agro 2000 - Maintenance

P A G E | 12
Wintex Agro, Vilhelmsborgvej 8C, DK-7700 Thisted
+45 97990800, contact@wintexagro.com, www.wintexagro.com
14. MAINTENANCE
Daily:
After three hours in use tighten all screws and bolts.
Check the chain for rotation. Lubricate if necessary.
Check the upper end of the probe. Lubricate if necessary.
Check the grease fitting for rotation. Lubricate if necessary.
Check all screws and bolts.
Clean the probe and the ejector.
Clean the soil box.
Clean the scraper blades.
Common cleaning of the soil sampler.
Check the level of the hydraulic oil and refill with oil if necessary.
Check the hydraulics for leaks.
Clean the oil tank.
Clean the oil cooler.
Check weekly and exchange/adjust if necessary:
50101038
Guiding rolls
16101022
Guiding pipe
16101002
Rotary sensor plate
50101044
Slide bearing
50101045
Gearwheel for rotation, 30 teeth
50101046
Gearwheel for rotation, 12 teeth
Check daily and exchange if necessary:
50101004
O-ring for scraper
50101003
Scraper
50101014
Scraper blade
50101039
Spring roll pin for scraper
16101001
Probe
Exchange after 500 hours in use and at least once a year:
10000002
Hydraulic oil filter
10000002
Hydraulic oil
Exchange if necessary:
15101196
Oil level rod with filter cap
Honda GX200 motor:
See instruction manual