WinZo WZ5028 - User Manual

To Next Page

WINZO

WINZO WINZO

WINZO

Installation Instruction

For One Piece Toilet

Model:WZ5028/AN5028

IMPORTANT!

PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE

The toilet must be installed by a fully insured and licenced plumber only.

Also be sure the installation conforms to local plumbing and building codes.

TOOLS REQUIRED FOR INSTALLATION

Soft Cloth

or Blanket

Silicone Silicone/

Caulk Gun

Tape

Measure

Pencil/Marker

Knife

Adjustable

Wrench

Screwdriver

Level

Putty Knife

INSTALL NEW TOILET

REMOVE OLD TOILET Shut off main water supply prior to installation!

1. Shut off water supply line. If you do not have shut-off valve near the toilet shut off main water supply line.

2. Flush the old toilet and make sure that tank is empty.

3. Disconnect and remove water supply line connected to the toilet's tank.

4. Remove old toilet, bolts, nuts from the closet flange.

5. Clean closet flange area from old wax ring and putty sealant using putty knife from the base area.

6. Clean any remaining debris and wipe any water at the installation area

7. Temporarily plug flange on a floor with a flange plug or towel to prevent gasses from escaping

,03257$177KHPRXQWLQJVXUIDFHDUHDPXVWEHFOHDQGU\

DQGOHYHOHGSULRUWRLQVWDOODWLRQRIWKHQHZWRLOHW

127(,QVSHFWWKHH[LVWLQJFORVHWIODQJHIRUGDPDJHV,I

GDPDJHGUHSODFHLWWRQHZIODQJHEHIRUHSURFHHGLQJWRWKH

LQVWDOODWLRQ

Thanks for your selecting our products. To ensure this product is installed properly, please read these instructions carefully before you begin.

1. If it is a new bathroom, install water supply ,shut-off valve,

and toilet flange as necessary to conform to the roughing-in

dimensions.

Bathroom

Wall

Bathroom

Floor

Closet Flange

12"

Rough-in

Figure 1

Step 1 Step 2

90º

3. Cover the floor with the soft-cloth blanket.

Carfeully turn the toilet on it’s side or

upside-down on the blanket. Install wax ring on

the toilet outlet.(see Figure 2)

Figure 2

4. Lift and carefully put the toilet over the

closet flange so the closet bolts can go through

the mounting holes in the toilet's base. Apply

full body weight to rim of bowl for proper

gasket seal.(see Figure 3)

Bolt cap

Nut

Bolt Cap Base

Washer

Plastic cover

5.Install bolt cap bases, washers,nut

and bolt cap over the closet bolts via

the opening holes on both side of

bowl. Do not tighten the nuts. It may

and will cause damage to the toilet's

ceramic base. Then cover the opening

holes with supplied plastic cover. (see

Figure 4)

6. Connect the water supply line,and

turn on the water. Flush several times,

check for leaks. (see Figure 5)

7. If necessary, adjust the water level

in the water tank. Turn the adjusting

screw clockwise to raise the water or

Turn the screw counter-clockwise to

reduce water. (see Figure 5)

Refill Tube

Adjusting Screw Waterline

Supply Line

Shut-off Valve

8. Make sure the refill tube is

properly inserted into the

overflow pipe of the flush valve.

Refill tube should be positioned

higher than water level. (see

Figure 6)

Overflow Pipe

9. Install the push button on the tank

lid.Make sure the button rods could

touch the top surface of flush valves

and ensure the buttons match the half

and full flush.

(Button rods could be adjusted by

turning the adjustment nuts)

2. Inser 2 floor bolts inside of the toilet flange and slide the bolts

through the holes and align bolts horizontaly. (see Figure 1)

Figure 3

Figure 4

Figure 5

RIGHTWRONG

Water

Level

Figure 6

WinZo

Button Rods

Adjustment nuts

Tank lid

Button Nut

Flush Valve

Half

flush

Full

flush

10. Put the tank lid on the tank.

Install the seat cover in accordance

with detailed manual on Page 3)

(see Figure 8)

Figure 8

Figure 7

1/3

4-1/2”

Need help?

Do you have a question about the WinZo WZ5028 and is the answer not in the manual?

This document provides comprehensive installation and maintenance instructions for the WinZo Model WZ5028/AN5028 One Piece Toilet.

Function Description:

The WinZo WZ5028/AN5028 is a one-piece toilet designed for bathroom use, featuring a dual-flush mechanism for water conservation. It integrates the bowl and tank into a single unit, offering a sleek and modern aesthetic. The toilet is designed for efficient waste removal and includes features for easy installation and maintenance.

Important Technical Specifications:

Model: WZ5028/AN5028
Type: One Piece Toilet
Rough-in Dimension: 12 inches (from bathroom wall to the center of the closet flange)
Water Level (Tank): Adjustable, with a recommended level of approximately 4-1/2 inches from the bottom of the overflow pipe.
Flush Mechanism: Dual-flush (half flush and full flush) operated by a push-button on the tank lid.
Water Supply Connection: Standard water supply line connection with a shut-off valve.
Mounting: Floor-mounted using closet bolts and a wax ring for sealing.
Material: Vitreous China for the toilet body, with plastic components for internal valving, push buttons, and the toilet seat.

Usage Features:

Dual Flush: The toilet features a dual-flush push-button system on the tank lid, allowing users to select between a half flush (for liquid waste) and a full flush (for solid waste). This promotes water conservation by using only the necessary amount of water per flush.
Adjustable Water Level: The water level in the tank can be adjusted by turning a screw on the fill valve. Turning clockwise raises the water level, while turning counter-clockwise lowers it, allowing users to customize water usage or address specific flushing needs.
Easy Toilet Seat Installation: The toilet seat is designed for straightforward installation and removal. It uses fixing bolts that insert into the seat holes of the pan, with a mechanism that allows for temporary tightening for positioning and then firm tightening once the desired position is achieved. The seat can be easily released for cleaning by pressing two release buttons.
Stable Mounting: The toilet is secured to the floor using closet bolts, ensuring a stable and secure installation. The installation process includes steps to prevent damage to the ceramic base during tightening.
Integrated Design: As a one-piece toilet, it offers a seamless design that is generally easier to clean than two-piece models, as there are no gaps between the tank and bowl to collect dirt.

Maintenance Features:

Easy Cleaning: The smooth, integrated surface of the one-piece toilet, combined with the removable toilet seat, facilitates easy cleaning. The manual specifically recommends using warm water, soft sponges, or soft cloths for general cleaning.
Troubleshooting Guide: The manual includes a detailed troubleshooting section for common issues such as poor flush, low flush volume, and water leaking or failing to shut off in the tank. This guide provides potential causes and corresponding solutions, empowering users to address minor problems without professional assistance.
Adjustable Components: Key internal components, such as the refill tube and push-button rods, are adjustable. The refill tube's position relative to the overflow pipe can be checked and adjusted, and the length of the push-button rods can be adjusted by turning nuts to ensure proper contact with the flush valves for effective half and full flushes.
Replaceable Parts: The design implies that internal valving and plastic components are replaceable, as indicated by the warranty terms.
Clear Cleaning Guidelines: The manual provides explicit instructions on what cleaning agents and tools to avoid to prevent damage to the toilet's finish and internal components. It warns against abrasive cleaners (acid, ammonia, bleach), abrasive sponges/cloths (steel wool, wired brushes), and pouring chlorine or other chemicals into the tank, which could damage the fill and flush valve components and lead to leaks or property damage.
Warranty: The product comes with a five-year warranty for the Vitreous China body and a one-year warranty for internal valving and plastic components, subject to specific conditions such as professional installation, home use only, no additives in the tank, and proper cleaning methods. Proof of purchase is required for warranty claims.

Installation Process Highlights:

The installation process is detailed and requires specific tools such as a soft cloth, silicone, tape measure, pencil/marker, knife, adjustable wrench, screwdriver, level, and putty knife. Key steps include:

Preparation: Shutting off the main water supply, removing the old toilet, cleaning the closet flange area, and ensuring the mounting surface is clean, dry, and level.
Flange and Bolts: Installing floor bolts into the closet flange and aligning them horizontally.
Wax Ring: Carefully turning the toilet on its side (on a soft cloth) and installing the wax ring on the toilet outlet.
Placement: Lifting the toilet and carefully placing it over the closet flange, ensuring the bolts go through the mounting holes. Applying full body weight to the bowl rim to ensure a proper gasket seal.
Securing: Installing bolt cap bases, washers, nuts, and bolt caps over the closet bolts. The manual warns against overtightening to prevent damage to the ceramic base.
Water Connection: Connecting the water supply line and turning on the water. Flushing several times to check for leaks.
Adjustments: Adjusting the water level in the tank if necessary and ensuring the refill tube is properly inserted into the overflow pipe.
Push Button Installation: Installing the push button on the tank lid, ensuring the rods touch the flush valves and match the half and full flush functions. The rods are adjustable.
Lid and Seat: Placing the tank lid and installing the toilet seat according to the separate toilet seat installation instructions.
Sealing: Applying silicone around the base of the toilet and checking for leaks over several days once dry.

The manual emphasizes the importance of handling the product with care due to its fragile nature and recommends installation by a fully insured and licensed plumber in accordance with local plumbing and building codes.

WinZo WZ5028 Specifications

General

Brand	WinZo
Model	WZ5028
Category	Toilets
Language	English

Related product manuals

WinZo WZ5081

2 pages