20
EN
DE
FR
+44 (0)20 78941516 info
@
topregal.com www.topregal.com
WIPEKET
When closing the cover, make sure that the batteries are positioned correctly.
CHANGING THE BATTERIES
• Disconnect the negative (-) battery cable first and then the positive (+) cable
before removing the battery.
• When reconnecting, make sure that the electrodes are properly connected, as i
correct connection may damage the electrical components. Do not touch the poles
of the battery.
• Avoid direct contact between the positive and negative terminals as this can cause
a current short circuit and possibly cause a fire.
TROUBLESHOOTING
Problem
Cause Solution
Water is not drawn in
The suction motor is not switched on Switch on the suction motor
The waste water tank is full Empty the waste water tank
The wiper bar or the suction pipes are clogged or defective Check all connectors and hoses on the machine
Wiper bar is misaligned Check the alignment of the wiper lips
The batteries cannot be
charged
The batteries are damaged Replace the batteries
The charger is damaged Replace the charger
The batteries are deeply discharged Charge the batteries longer / replace them
The floor is not
scrubbed properly
The brush motor is damaged Have the machine serviced
Excessive wear of the brush Replace the brush
Driving too fast over dirty areas Go slowly over particularly dirty areas
There is not enough water in the fresh water tank Top up with water
The machine does not
start
The batteries have not been charged Check the charge level of the batteries
The emergency stop switch is activated Deactivate the emergency stop switch
The motor is defective Contact our customer service
Protect the environment
Please dispose of the old machine parts such as packing material, battery, etc. and toxic liquids such as
antifreeze and oil according to the local regulations for waste disposal and on the premise of maintaining
environmental safety. Make sure that recycling is carried out properly.
WARRANTY
The warranty of one year from the date of invoice covers material, manufacturing and construction defects. Damages,
which are due to natural wear and tear, improper handling or unauthorized modification are not covered by the warranty.
To Next Page
Loading...
