INSIGHT SERIES P6i WISDOMAUDIO.COM
(not from one end to the other), to avoid damaging the grille. Set it aside, laying
it at.
3. Push any insulation in the wall to the side. If there is no insulation in the wall,
loosely fill the stud bay with insulation to reduce cavity resonances and improve
performance.
4. Using assistance to hold the speaker away from the wall, connect the speaker
cable to the + and – connectors on the rear of the speaker, paying attention to
proper polarity.
5. Make sure all the speaker clamps are retracted in their “ready-to- mount”
position at the tops of the mount towers, tucked within the mounting opening's
border.
6. Insert the speaker straight into the mounting opening. Tighten the speaker
clamp screws on the front of the speaker baffle. The speaker clamps will
automatically rotate into position and begin clamping the speaker.
7. When you notice resistance on the screws the speaker has been clamped
successfully. IMPORTANT: Always use low-torque settings. NEVER over-tighten
the clamp screws.
The P6i and Subwoofers
All Insight Series loudspeakers are optimized for use with subwoofers, with a crossover
of 80 Hz. (This is the most common frequency below which subwoofers are used.)
When properly installed in the wall, your P6i has inherently at response to 80 Hz,
without the common “bass bump” that characterizes most in-wall speakers and is
placed there to yield the impression of “more bass” than there really is. This makes it
easy to blend seamlessly with a high-quality subwoofer such as one of Wisdom Audio’s
Regenerative Transmission Line™ (RTL™) subwoofers.
You should setup your surround processor speaker bass management to “Small” and or
with an 80 Hz crossover to maximize the speaker’s output. Doing so ensures that
all content below 80 Hz is directed to the subwoofer(s) for reproduction.
To Next Page
Loading...