p. 51
2.4 Assembly of the scooter
9. Unfold the scooter (instructions below).
10. Unscrew the two screws at the top of the stem using the Allen
key provided, then remove the plastic cover as shown in the
illustration.
11. Grab the cables inside the tube, and highlight the connectors outside the
tube, being careful not to drop them into the tube.
12. Then pull the brake cable and insert it into the notch as
follows:
13. Insert the sheath into the threader on the handle.
14. Connect the cables of the handle with the cables inside
the tube. Be aware of the shape and colour of the
connectors. There are safety notches to help you insert them the right way
round, you don't have to force them.
15. Insert the handlebars into the battery tube in the direction
shown (it should not force and should slide easily). The
holes in the handlebars must be aligned with the holes in
the stem.
16. Finish the assembly by screwing back in the two screws of the hook.
To Next Page
Loading...
