p. 62
➢ If the braking is too soft, the cable must be retightened.
• Use the 4mm Allen key provided.
• Loosen the screw by turning it
counter-clockwise.
• Pull the brake cable back slightly.
• Tighten the screw by turning it
counter-clockwise.
• Repeat if necessary to fine-tune it
• 7.4.2 Maintenance of screws:
Check the screws of each part carefully before using the scooter. The screws
must not be loose or too damaged.
• 7.4.3 Adjusting the Stem:
If you feel vibrations while riding, you may need to check the tightness of the
wheel.
➢ Lift up the plastic tabs at the
bottom of the stem on the deck
side.
➢ Use the Allen key to tighten
the screws.
To Next Page
Loading...
