How to troubleshoot a power failure in Witeg Laboratory Equipment?
If your Witeg Laboratory Equipment isn't powering on, here's what to check: * First, ensure that the supplied voltage is present. * Next, verify the power connection and cord are properly connected and undamaged. * Confirm that the MAIN Power Switch is in the “ON” position. * Also, check if the fuse is blown.
Why is my Witeg WB-6 not heating up?
If your Witeg Laboratory Equipment is not heating, please check the following: 1. Ensure the MAIN Power Switch is turned “ON”. 2. Confirm the set temperature (SV) with the Jog-Shuttle knob. 3. Verify that the Safety switch is set higher (min. 10°C-20°C) than the set temperature (SV).
What to do if Witeg WB-6 is heating, but not reaching temperature?
If your Witeg Laboratory Equipment is heating but not reaching the desired temperature, verify that the Safety switch is set higher (min. 10°C-20°C) than the set temperature (SV). There may also be a problem with the sensor or main controller.
General| Type | Water Bath |
|---|---|
| Temperature Stability | ±0.1°C |
| Temperature Uniformity | ±0.2°C |
| Capacity | 6 liters |
| Material | Stainless Steel |
| Controller | Digital PID Controller |
| Power Consumption | 600W |
| Weight | 4.5 kg |
| Timer | 99hr 59min (with continuous run function) |
| Safety Features | Over-temperature protection |
| Power Supply | 220V / 50~60Hz |
To Next Page
