Need help?Do you have a question about the Witt OXYBABY 6 and is the answer not in the manual?
General| Gases | O2, CO2 |
|---|---|
| O2 Measuring Range | 0-100% |
| Power Supply | Rechargeable battery |
| Display | LCD |
| Data Logging | Yes |
| Interface | USB |
| Resolution | 0.1% |
| Battery Life | Approx. 8 hours |
| Weight | 300 g |
Step-by-step guide to powering on the OXYBABY® device.
General steps for performing measurements with the device.
Detailed steps for taking measurements in Sample Hold mode.
Detailed steps for taking measurements in Permanent mode.
Instructions on how to properly switch off the OXYBABY® device.
General information and steps for calibrating the OXYBABY®.
Steps to calibrate the zero point for O2 and CO2 sensors.
Steps to calibrate the O2 sensor at the 20.9% measuring point.
Steps to calibrate the CO2 sensor at the 100% measuring point.
Table listing fault messages, their causes, and remedies.
Key points for maintaining the OXYBABY® for long-term reliability.
Troubleshooting steps for clogged needle or filter issues.
To Next Page
