7
11- Trouble shooting
Readout issues
The Digital Readout may display numbers counting randomly when the unit is turned
“ON”, but not on the track with the sensor strip. This is normal and does not mean your
Readout is defective.
Unstable constantly scrolling numbers
• Insure the sensor strip is properly oriented as shown on Page 4 step 7 in the
manual.
• Check that the Readout is not too loose on the track. If needed adjust the 6
screws as shown on Page 5 step 8.
• Remove the battery, wait 30 seconds and replace it.
Flashing digits, dim, or no display
• Install a new battery.
• Clean battery and battery contacts
Frozen display
• Remove the battery, wait 30 seconds and replace it.
Loses calibration
• Check that the Readout is not too loose on the track. If needed adjust the 6
screws as shown on Page 5 step 8.
• Check for static discharges from nearby dust collector or other source
For questions, comments, and application examples go to: www.wixey.com
To Next Page