Integrated Modules
Integrated Modules
Electronics and Gas Theory
2-2
#826498 - Revision B - December, 2016
ELECTRONICS
This section describes the basic operation of the module electronics and how the touch pad responds to input com-
mands. The electronics operation of the CE152TF/S, CI152TF/S, SM15TF/S, FM15TF/S, GM15TF/S, and the
TM15TF/S are very similar. Model specific information is listed below the general operation.
Touch Pads
Global Touch Pads - All Models
LOCK - Locks or unlocks the entire unit. Touch and hold for 3 seconds. Acceptance beep when state•
changes. Padlock is displayed when locked.
ALL OFF - Disables entire unit. Red circle displayed when any heating component is in use.•
“+” - Adds time to the count down timer. Valid Selection beep to acknowledge touch.•
“-” - Decreases time to the count down timer. Valid Selection beep to acknowledge touch.•
TIMER - Activate and deactivate the timer. Valid Selection beep to acknowledge touch.•
Control Zone Pads
ON/OFF - Enables or disables individual control zone.•
SIM - sets power to level 1.•
MLT - sets power to level 1.•
LO - sets power to level 1.•
HI - sets power to level 10.•
ZONE 2 - CE152TF/S - Activates Zone 2 on hobs with two or more zones.•
BOOST - CI152TF/S - sets power to Boost and adjusts adjacent power levels as required by the induction•
power sharing scheme. Toggles Boost off if already engaged.
BRIDGE - TM15TF/S - Activates adjacent induction coil to same power level.•
DRAIN - SM15TF/s - enables or disables the electronic drain valve.•
“+” (temperature) - SM15TF/S and FM15TF/S - increases the set temperature by one degree.•
“-” (temperature) - SM15TF/S and FM15TF/S - decreases the set temperature by one degree.•
‘’ . . . .” - Sets power to levels 2 through 9.•
Annunciator - All Models
Unit must be in idle mode to adjust annunciator.•
Adjust annunciator volume and frequency in user options mode. See Frequency Duration and Selection•
Chart on the next page.
Factory default setting for volume is medium.•
Factory default setting for frequency is medium. •
Low frequency is 1.5 kHz. Medium frequency is 2.0 kHz. High Frequency is 2.5 kHz.•
To Next Page
Loading...
