Integrated Modules
Integrated Modules
Electronics and Gas Theory
2-16
#826498 - Revision B - December, 2016
h. Software Version Indicator - CE152TF/S, CI152TF/S, and TM15TF/S
Touch “+” pad during Showroom Mode. 1.
CE152TF/S and CI152TF/S - eight “.” displayed on rear control zone.•
TM15TF/S - eight “.” displayed on front control zone.•
2-digit display cycles to show the software version of the control.2.
“-” pad engages the Showroom Mode menu.3.
h. Software Version Indicator - SM15TF/S, FM15TF/S, and GM15TF/S
Touch “+” pad during Showroom Mode. 1.
Seven “.” displayed on rear control zone.•
2-digit display cycles to show the software version of the control.2.
“-” pad engages the Showroom Mode menu and “.” pad advances to LED test.3.
User Options Mode - All Models
Entering User Options Mode
Unit must be in Idle Mode.1.
Touch and hold ALL OFF pad for 5 seconds.2.
After 5 seconds a valid selection beep sounds alerting the user to remove their finger.•
If any other key pad sensor detects a signal, User Option Mode does not engage. •
If the ALL OFF pad is not released after 7 seconds, User Option Mode does not engage.•
Power to all heating assemblies is disabled in User Option Mode.•
If after 60 seconds no inputs are detected while in User Option Mode, the control returns to Idle Mode.•
If the ALL OFF pad is touched at any time while in User Option Mode, the control returns to Idle Mode.•
Use the “+” and “-” pads to step through the settings.3.
Rear “…” display advances one LED for each setting. The number of “...” on identifies which setting is•
being adjusted.
TM15TF/S - front “…” display advances one LED for each setting. The number of “...” on identifies•
which setting is being adjusted.
User Options
a. Annunciator Volume - All Models
One “.” displayed on the rear control zone.•
TM15TF/S - one “.” displayed on the front control zone.•
Uo displayed on the 2-digit display.•
The “.” displayed on the front control zone shows the current volume level.•
TM15TF/S
- the “.” displayed on the rear control zone shows the current volume level.•
Power level 1 for low, power level 5 for medium, and power level 10 for high.•
As the volume is adjusted, the annunciator sounds a tone at the newly selected setting. 1.
Touch the front control zone MLT/SIM/LO pad or HI pad to adjust the volume up or down. •
TM15TF/S - touch the rear control zone LO pad or HI pad to adjust the volume up or down.•
A touch of the “+” pad advances the user options mode to Annunciator Frequency.2.
To Next Page
Loading...
