Wolf MWC24 Use & Care Guide

Convection Microwave Oven Installation 11
wolfappliance.com
Installation
BUILT-IN APPLICATION
Your convection microwave oven can be built into a
cabinet or wall by itself or can be used above a Wolf
L series or E series built-in oven.
Refer to installation instructions provided with the
microwave oven trim kit and the Wolf built-in oven (if
applicable). Do not install above any other type of built-in
oven. The trim kit includes finish trim strips, ducts,
installation instructions and information on the location
of the power supply. To order the trim kit, contact your
authorized Wolf dealer.
Be sure to check the local building code as it may require
that the opening be enclosed with sides, ceiling and rear
partition. The proper functioning of the microwave oven
does not require the enclosure.
FREESTANDING APPLICATION
You will use the microwave oven frequently, so plan its
freestanding location for ease of use. If possible, allow for
counter space on at least one side of the oven. Allow at
least 2"
(51) of space on the sides, top and at the rear of
the oven for air circulation.
UNPACK THE MICROWAVE OVEN
Remove and recycle all packing materials from the exterior
and inside the oven cavity. Do not remove the waveguide
cover, which is located on the top of the oven cavity. Refer
to the illustration on page 8. Read enclosures and save
this use & care guide for future reference.
Check the oven for any damage, such as misaligned or
bent door, damaged door seals and sealing surfaces,
broken or loose door hinges and latches and dents inside
the cavity or on the door. If there is any damage, do not
operate the microwave oven and contact your dealer or
Wolf factory certified service.

Wolf MWC24 Specifications

General

Brand	Wolf
Model	MWC24
Category	Microwave Oven
Language	English