Convection Microwave Oven Care 32
INTERIOR
Cleaning is easy because little heat is generated to the
interior surfaces; therefore, there is no baking and setting
of spills or spatters. To clean interior surfaces, wipe with a
soft cloth and warm water. Do not use abrasive or harsh
cleaners or scouring pads. For heavier soil, use baking
soda or a mild soap; rinse thoroughly with hot water.
Do not use chemical oven cleaners.
TURNTABLE
The turntable and turntable support can be removed for
easy cleaning. Wash turntable, turntable support and
accessory racks in water with a mild soap; for stubborn
stains use a mild cleanser and a non-abrasive scouring
sponge. They are also dishwasher-safe. Use top rack of
dishwasher for the turntable support.
The turntable motor shaft is not sealed, so excess water
or spills should not be allowed to stand in this area.
ODOR REMOVAL
Occasionally, a cooking odor may remain in the microwave
oven. To remove, combine 1 cup
(240 ml) water, grated
peel and juice of one lemon and several whole cloves in a
2-cup
(480 ml) glass measuring cup. Boil for several
minutes using 100% power. Leave in the oven until cool.
Wipe the interior with a soft cloth.
Cleaning and Care
The waveguide cover, located inside on the top of the
oven interior, is made from mica, so it requires special
care. Keep the waveguide cover clean to assure good
microwave performance. Carefully wipe with a soft
damp cloth any food spatters from the surface of the
cover immediately after they occur. Built-up spatters
may overheat and cause smoke or possibly catch fire.
Do not remove the waveguide cover.
Disconnect the power cord before cleaning or leave the
door open to inactivate the oven during cleaning.
EXTERIOR
Clean exterior surfaces of the microwave oven with mild
soap and water; rinse and dry with a soft cloth. Do not use
any type of household or abrasive cleaner.
Wipe the window on both sides with a soft damp cloth to
remove any spills or spatters. Metal parts will be easier to
maintain if wiped frequently with a soft damp cloth. Avoid
the use of spray and other harsh cleaners as they may
stain, streak or dull the door surface.
STAINLESS STEEL TRIM
The stainless steel trim should be wiped often with a soft
damp cloth and polished with a soft dry cloth to maintain
its beauty. There are also a variety of products designed
especially for cleaning and shining stainless steel. We
recommend that the cleaner be applied to a soft cloth and
then carefully wiped over the stainless steel trim, rather
than applied directly to it. Follow package directions.
CONTROL PANEL
Care should be taken in cleaning the touch control panel.
If the control panel becomes soiled, open the door to
inactivate the oven controls before cleaning. Wipe the
panel with a cloth dampened slightly with water only. Dry
with a soft cloth. Do not scrub or use chemical cleaners.
Close door and touch STOP/CLEAR.
To Next Page
Loading...
Need help?
General
