1. Fix the rear camera with 3M adhesive
Find the best position , tear off the 3M adhesive
on the rear camera and install the rear camera near
the license plate lamp.
Hardwire Kit Installation
Dedicated Hardware Kit ASIN: B09X1L1GMX
1. Stop the engine.
2. Open the fuse box.
3. Use a power detector to detect the constant power and ACC power (emergency power). *note:
Use an ACC power supply of 15A to 25A.Use a constant power supply below 30A.
4. Connect the yellow fuse to the constant power source, the red fuse to the ACC power source,
and the ground terminal (black wire) to the metal part of the body.
Installation - Connect the following three cables to the car fuse box.(The position of the fuse box
differs depending on the model)
24
Step:
To Next Page
Loading...
