2. If still not work after reconnection, there may be a problem with the cable. Because when
wiring in the car, it may cause the metal wire in the rubber to bend and cause a short circuit.
Please CONTACT US and we will solve it for you.
Why can't it automatically switch to the rear camera when reversing or why can't the reversing
line appear?
1. Check if the 4pin is loose, and if the rear camera port of the dash cam is loose.
2. Check whether the red wire of the rear camera cable is connected to the positive pole of the
reverse light, please do not connect it to the brake light or other.
3. If the connection is correct, please use a tester to measure whether the voltage is output
from the reversing light when in reverse gear.
Why dash cam does not work/cannot be turned on/freezes/restarts repeatedly?
1. Unplug the GPS, card, and rear camera cable, reset after power on again, and try to see if it
can be turned on.
2. If the above does not work, please contact us.
43
To Next Page
Loading...
