8
l
Konformitätserklärung nach der EG-Maschinenrichtlinie 2006/42/EG, Anhang II A
Hiermit erklärt die Firma wolfcraft GmbH in D-56746 Kempenich, Wolff Str. 1, dass dieses Produkt (6197000)
der Maschinenrichtlinie 2006/42/EG entspricht.
Kempenich, 30.09.2015
Thomas Wolff
Bevollmächtigte Person zur Unterzeichnung der Konformitätserklärung und zur Zusammenstellung der technischen
Unterlagen.
(Geschäftsleitung; wolfcraft GmbH)
t
Safety instructions
• It is essential to comply with the safety instructions of the manufacturers who made your drive machines.
• These appliances must conform to the VDE regulations. Appliances built after 1995 must have CE certification.
• Always disconnect the power supply:
– before changing attachments
– before changing work pieces
– before maintenance jobs
– while the equipment is not in use.
• Before commencing work, test the operability of the equipment and the tools. Never work with damaged or blunt tools.
• Before commencing work, check that the equipment is mounted correctly (e.g. check screwed joints).
• Firmly clamp the work piece into position.
• Ensure that the equipment is firmly supported and that you are standing in a stable position and on firm ground.
• When using equipment and tools be sure to follow the data that is specified on the product, the packaging
or in the operating instructions concerning minimum/maximum speeds and the rotation direction.
• The tools should only be used for their intended purpose.
• Never remove any protective devices.
• Ensure that your clothes (especially sleeves) are not flapping around and protect your hair.
• Protect your ears when carrying out work which pro duces a high level of noise.
• Wear safety goggles and protection for the mouth and nose when carrying out work which produces dust, shavings,
fumes or sparks.
• Never work towards your body.
• Never reach into the equipment while it is in operation.
• Ensure that all electrical equipment is protected against damp, dust and humidity.
• Keep children away from your workshop and store your equipment and tools in a safe place.
• Never allow inexperienced persons to work with your equipment and tools without instruction or supervision.
• Always plan your work carefully and be sure to maintain concentration.
Intended use
• The jigsaw table is an accessory for your jigsaw.
• For parallel cuts using a parallel stop.
• For commercially available jigsaws with a maximum saw blade length of 100 mm.
• For fastening with two clamps to work tables with a maximum thickness of 60 mm
SYMBOLE UND BEDEUTUNG
Warning against a general danger
Read the instructions!
Goggles must be worn.
Hearing protection must be worn.
Pull the plug.
Dust mask must be worn.
Wear protective gloves.
Bdal 6197.000 116316197 08.10.15 14:31 Seite 8
To Next Page
Loading...
