10
English
• Power Saver Mode: when powered on, long press for three seconds until the screen ashes, then press again to select H(High),
M(Middle) and L(Low) energy use settings.
(*Factory setting is H.)
Due to the dierent output voltages between vehicles, Set to H when the product is connected to car power, and M or L when it is connect-
ed to a portable battery or other back-up battery.
The battery gear should be set from H to M or from M to L if there is a voltage protection code F1 shown on the panel. The battery gear
should be set to H if the product keeps working after turning o the car engine, or the product may drain the battery.
To Next Page
Loading...