Wolo RC-100 - User Manual

To Next Page

Your choice of Wolo’s remote control switch system is the perfect choice to compliment your vehicle or vessel.

Wolo’s products are manufactured with the ﬁnest quality materials and every remote system is inspected

and tested before being packaged. The Wireless Wizard is built with state-of-the-art electronics, assuring

years of reliable service. If you need help installing your new Wolo remote system, or have any questions,

our technicians are available to answer your questions, Monday through Friday from 9 AM to 4 PM EST

at 1-888-550-HORN (4676)

THERE ARE TWO OPERATING MODES TO CHOOSE FROM:

1. HORN MOMENTARY MODE: When the remote’s push button is pressed, it will illuminate blue, to advise

that a coded signal is being wirelessly transmitted to the receiver. The receiver will then turn on and power

the horn until the remote’s push button is released. Press the remote’s button switch, the horn will sound;

release button switch and the horn will turn off.

2. ACCESSORY ON / OFF MODE: When the remote’s push button is pressed, it will illuminate blue, to advise

that a coded signal is being wirelessly transmitted to the receiver. The receiver will then turn on and power

the accessory. The accessory will remain powered until the remote’s push button is pressed and released

a second time. Press and release the remote’s button switch, turn on the accessory. Press and release the

remote’s button switch a second time and the accessory will turn off.

Before installation of the Wireless Wizard is attempted, it is important to read these instructions completely and

note any messages marked “IMPORTANT”.

MOUNTING REMOTE TRANSMITER: Fig. 1

3. Open the battery compartment by pushing downward on the cover. Insert

the battery provided. IMPORTANT: Position the battery as illustrated by

the diagram inside the battery compartment.

4. Press the remote’s button switch and it will illuminate blue. If the button

does not illuminate, remove the battery and reverse the direction.

5. Slide the battery cover back into position. The remote control transmitter

is now ready to be mounted. Locate a ﬂat surface that can easily be

reached. IMPORTANT: Always carefully inspect mounting location to

ensure that it will not interfere with the air bags, vehicle’s operation,

or impair the driver’s vision. Consult the vehicle’s shop manual or

dealer if the installer is not familiar with the deployment area of the air

bags.

6. IMPORTANT: Never mount the remote transmitter on the steering wheel.

Doing such could cause injury or death if the air bag is deployed.

7. Using the Velcro

tape provided, mount the remote control transmitter to the desired location. Make sure

that mounting surface is free from dust, wax, oil and etc. A clean mounting surface is necessary for the tape

to adhere properly.

IMPORTANT: THE TAPE’S ADHESIVE HOLDING POWER BECOMES MAXIMUM IN 24 HOURS. LIMIT

MOVING OR PUTTING PRESSURE ONTO THE REMOTE TRANSMITTER UNTIL THEN.

INSTALLATION INSTRUCTIONS FOR MODEL RC-100 • WIRELESS WIZARD

Fig. 1

Peel off

Battery

Compartment

Peel off

Need help?

Do you have a question about the Wolo RC-100 and is the answer not in the manual?

Wolo RC-100 Specifications

General

Brand	Wolo
Model	RC-100
Category	Remote Control
Language	English

Wolo RC-100 - User Manual

Summary

Mounting Remote Transmitter

Operating Modes

Remote Transmitter Mounting

Mounting Receiver

Receiver Mounting Steps

Wiring Receiver to Horn or Accessory

Horn or Accessory Wiring

Wiring Receiver to 12-Volt Power Source

Power Source Wiring

Fuse Selection and Wire Lengthening

Fuse Selection

Wire Lengthening

Programming Remote Transmitter & Receiver

Programming Procedure

Operation

Receiver Switch Setting

Receiver Fuse

Warranty Information