Wolverine Airsoft STORM - Page 7

Page 7
www.wolverineairsoft.com
Maintenance
Your STORM regulator is designed to require very little maintenance.
However if you feel the regulator is in need of lubrication you can
disassemble by removing the three flat head screws from the side of
the regulator. Use TechT Gun Sav or another O-ring safe lubricant
on all o-rings and reassemble.
Pressure
adjustment
screw
Base Plate
5mm Ball Bearing
Spacer
AS-568
010 O-Ring
Shims
Spring
1.2 x 5mm
O-Ring
Piston
Tournament
Lock
1.2 x 17mm O-Ring
Gauge
Screw (x3)
1/8” MPT
Connector
Reg Seat
Assembly
AS-568 016
O-Ring
STORM
HighPressure
1.5 x 15mm
O-Ring
AS-568
111 O-Ring
AS-568
113 O-Ring
*STORM InGrip
Correct
Reg Seat
Orientation