Wonderfire 9500261 - Operation Ofthe Fire

OPERATION
OFTHE
FIRE
Please
observe the
lmportant
Notes
on
page
1,
before attempting to use this appliance.
Please
read
these
instructions
thoroughly
before using the
fire lor
the
first
time.
For
your
safety this appliance
is manulactured
with
a
Flame
Sensing
Device which will
close off the
gas
supply
-
until
re-set
-
in
the event
of any
failure
of
the
gas
supply or
flame.
Please
keep
these
instructions in
a
safe
place.
The
Gas Control
This fire
is
controlled by
a
four-position
gas
control
mounted
on the
lower right-hand
side of the
right
hand
column,
behind
a
flush-fitting
access door.
In
addition to the OFF
position,
there
is
a
PILOT LIGHT
position,
and
two
HEAT
CONTROL
positions
(Figure
1,
below)
Figure 1
-
The lgnition
and Heat
Control
positions
lgnition
of the
fire is
by
an
integral
piezo
generator
which,
upon operation,
ignites
the
pilot
flame. The
main
burner
is lit from
this
pilot.
As
a safety
feature
this
fire is
equipped
with
a
flame-sensing
device
which will
shut off the
gas
supply
in
the event that the
flame is
extinguished.
Lightingthe Pilot
Ensure
that the
gas
supply
is
on.
Turn
the
gas
control
knob
to
the
OFF
position.
Depress
the control
knob
and turn anticlockwise untilthe
PILOT
position
is
reached. This
action
will
allow
gas
to
flow
to the
pilot,
and also simultaneously
operates
the
piezo
spark
generator
which will
ignite the
pilot
flame. Keep
the
knob
depressed.
Observe the
pilot
flame is
alight by
viewing
the
lower
edge of the fuel-bed
on
the
left-hand
side
of the
fire,
through the cast
iron fretwork
above the
fender.
(Figure
2
overleaf).
lf
the
pilot
flame
does
not light first
time, repeat
the
lighting
procedure
until
successful.
Once the
pilot
llame
has
become established,
keep
the control
knob
depressed
for
at
least
1
0
seconds
to allow the
flame-sensing
device to establish.
When
the control
knob is released
the
pilot
flame
should
remain
established.
lf
the
pilot
flame fails
to establish,
repeat
the
lighting
procedure,
this
time
keeping
the
knob
depressed
for longer.
Lighting
the
main
burner
Once the
pilot
light
has
been
established, the
main
burner can be
lit
by depressing
and turning
the
control
knob
anticlockwise to the
MAXIMUM
position (Figure
1
above)
Page 2