76
OPERATION
Wood-fire cooking is not the same as gas or
charcoal cooking. The techniques are different
and the flavours are exquisite. It is strongly
suggested that all new users of the Delecto
familiarize themselves with the Woodflame
technology by reading the following section.
Electronic control
The electronic control lets you adjust the fan setting and heat level.
Indicator lights for
the nine fan settings
Adjusting intensity of heat
Starting at low or at high intensity
On and off
Socket for Woodflame 6V adapters
IMPORTANT SAFETY PRECAUTIONS
• Using a power adapter other than a Woodflame
adapter may damage the Delecto’s electronic
control.
• Always keep the adapter cord well away from all
hot surfaces.
WARNING
• Always ensure all electric cords are placed in
a way that will prevent tripping in them and
possibly causing serious accidents.
• Using accessories other than those sold or
recommended by the manufacturer may damage
the appliance. Parts damaged under these
circumstances are not guaranteed by the
manufacturer.
Power supply
The electronic control is powered by the Woodflame adapter (110V
or 220V) or four 1.5V "D" batteries (not included).
Your Woodflame appliance may also be plugged into a vehicle ciga-
rette lighter (car, boat, etc.), using the 12V adapter sold separately.
110V 6V
➛
12V 6V
➛
220V 6V
➛
Assembling the collector trays
A) Place a grate face down. Take a collector tray and position it on the grate so that
the semi-circular opening is at the opposite end to the handle (see illustration).
B) Press to insert the tray in the grate. On the handle side and the semi-circular
opening side, the tray must be placed over the OUTSIDE edge of the grate. The
other two sides of the tray are to be inserted INSIDE the grate frame.
5
Positionning the grates
Before operating the Delecto, position grates on the unit and verify that the grates
slide freely from the centre of the unit to the sides and back.
If the grates catch the burner or the heat shield when sliding them sideways, check
that the burner, heat shield and collector trays are properly assembled.
6
Sides of the collector
tray over outside edge
of the grate
Sides of the collector
tray inserted inside
the grate
Assembling the burner
A) Place the thermal shield on the three notches at the centre of the casing.
B) Insert the burner inside the thermal shield.
4
➤
➤
IMPORTANT
Although the burner and the collector trays are
preassembled, the following two points should be
carefully read for optimal use of the Woodflame
Delecto barbecue.
WARNING
•Wear gloves to avoid injury or pinching fingers
when handling sheet metal parts or assembling
them. The edges of sheet metal parts can cause
injury if not handled with care.
HANDLE CAREFULLY.
• Always ensure collector trays are properly
snapped in place so they do not become loose
and fall off during cooking sessions.
A
B
To Next Page
Loading...