For more information contact…
WOODFORD MANUFACTURING COMPANY
2121 Waynoka Road, Colorado Springs, Colorado 80915 • Phone: (800) 621-6032 • Fax: (800) 765-4115
To view our complete product line visit: www.woodfordmfg.com
or email: sales@woodfordmfg.com
A Division of WCM Industries, Inc.
Model 22 & V22
HOT & COLD
Freezeless Wall Faucet
Rev 06/10 Form No. II22.101
NOTE: The packing nut, located behind the
handle, has been factory adjusted. If leakage
should occur after installation or use, the
packing nut can be tightened to stop the leak.
FIGURE
Model 22
Anti-siphon protected
FIGURE 1-22
5” Tube
Centers
Fasteners
Nozzle
2 1/4” Tube
Centers
Nozzle
Fasteners
Downward Pitch
2
1-1/8” Dia. Holes
Packing Nut
FIGURE 2-22
Model V22
Anti-siphon protected
FIGURE 1-V22
FIGURE 2-V22
Packin
Nut
Downward
Pitch
Wall faucets must be properly installed and
operated to insure drainage. Improperly
installed or operated wall faucets may freeze
and burst in freezing weather.
INSTALLATION INSTRUCTIONS:
1. Before installation, flush supply line to
remove any debris.
2. Drill (2) 1-1/8” diameter holes through the
wall in the desired location and insert the
faucet from the outside. FIGURE 1
a. Drill (2) holes for the horizontal
mounted Model 22 water tubes on
5” centers.
b. Drill (2) holes for the vertical
mounted Model V22 water tubes on
3 ¼” centers.
3. Install faucet with nozzle pointing down.
FIGURE 1
4. The water tubes must have a slight
downward pitch for proper drainage.
Proper drain angle is built in to the faucet
head if mounted on a vertical surface.
FIGURE 2
5. Secure faucet to the wall using
appropriate fasteners installed through the
holes in the flange. FIGURE 1
6. For a solder connection inlet, open faucet
to full open position before soldering.
Excessive heat can damage valve seat
rubber or stainless steel seat and factory
solder joint.
To Next Page
Need help?
General
