Woodland Mills HM122 User Manual (English)

Other manuals for Woodland Mills HM122

Questions and Answers:

Karen JonesAug 13, 2025

Why does the blade keep coming off my Woodland Mills HM122 Power Tool?

J
justinbellAug 13, 2025
The blade of your Woodland Mills Power Tool might be coming off the band wheels due to: * Inadequate blade tension. Make sure to tighten the blade. * Improper blade guide set up. The gap between guide blocks and blade should be correct. * Improper blade tracking. Adjust the blade tracking. * Worn belts. Replace them with new ones. * Dull blade. Install a new blade. * Pushing the mill too quickly. Reduce the feed rate and push the head slower through the log.

stephanie59Aug 17, 2025

What causes blades to break on a Woodland Mills Power Tool?

K
Kimberly AcevedoAug 17, 2025
Blades on the Woodland Mills Power Tool are breaking due to: * Too many blade sharpenings. Replace the blade. * Inadequate blade tension, which can cause binding between guide blocks when the blade is too loose. Make sure to tighten the blade. * Improper blade guide set up. The gap between guide blocks and blade should be correct. * Improper blade tracking. Adjust the blade tracking. * Pushing the mill too quickly. Reduce the feed rate and push the head slower through the log.

Log Loading

Manual

Cutting Capacity

22 inches (55.9 cm)

Blade Size

0.042 inches (0.106 cm) thick

Max Board Width

22 inches (55.9 cm)

Head Adjustment

Manual

Warranty

2 year

Engine

9.5 HP (301cc) gas engine