To Next Page
K
Karen JonesAug 13, 2025
Why does the blade keep coming off my Woodland Mills HM122 Power Tool?
- JjustinbellAug 13, 2025
The blade of your Woodland Mills Power Tool might be coming off the band wheels due to: * Inadequate blade tension. Make sure to tighten the blade. * Improper blade guide set up. The gap between guide blocks and blade should be correct. * Improper blade tracking. Adjust the blade tracking. * Worn belts. Replace them with new ones. * Dull blade. Install a new blade. * Pushing the mill too quickly. Reduce the feed rate and push the head slower through the log.
General
