Model W1671
***IMPORTANT UPDATE***
Applies to Models Mfd. Since 7/11
and Owner's Manual Revised 4/07
Phone #: (360) 734-3482 • Tech Support: tech-support@shopfox.biz • Web: www.shopfox.biz
COPYRIGHT © DECEMBER, 2019 BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
Printed in China#20839MN
We made the following changes to this machine since the manual was printed:
• Revised Inventory to show two shipping boxes and contents.
• Revised Assembly steps.
Aside from the information contained in this update, all other content in the owner's manual is
applicable and MUST be read and understood for your own safety.
IMPORTANT: Keep this update with the owner's manual for future reference. If you have any further
questions, contact our Technical Support.
READ THIS FIRST
M. Chisel Bushings (
5
⁄8",
3
⁄4") .................... 2
N. Clutch Collar ................................... 1
O. Hold-Down Rods (3
1
⁄2", 5
1
⁄2", 7
1
⁄2" ) ........ 3
P. Depth Stop Lock Lever ........................ 1
Q. Base .............................................. 1
R. Hardware (not shown)
—Base Bolts M14-2 x 40 (Base) ............... 2
—Hex Nuts M14-2 (Base) ...................... 2
—Flat Washers 14mm (Base) ................. 2
—Flat Head Screws M8-1.25 x 25 (Table) ... 2
—Phillips HD Screws M6-1 x 12 (Tool Tray) ... 2
—Flat Washers 6mm (Tool Tray) ............. 2
—Shoulder Screw M10-1.5 x 28 (Clutch) ..... 1
—Spring 18 x 2 x 26 (Clutch) ................. 1
—Shoulder Screw M4-.7 x 16 (Adj. Handle) .. 1
—Spring 4 x 1 x 8 (Adj. Handle) ............. 1
Figure 2. Box 2 inventory.
H I
J
K
L M
N
E
F
G
P
Q
O
Revised Inventory
Box 1 (Figure 1) Qty
A. Head & Column Assembly .................... 1
B. Hand Lever w/Stop Collars ................... 1
C. Wood Table .................................... 1
D. Fence ............................................ 1
Box 2 (Figure 2) Qty
E. Mortising Chisel
1
⁄2" ........................... 1
F. Gas Spring ...................................... 1
G. Tool Tray ........................................ 1
H. Hold Down ...................................... 1
I. Chuck Key ....................................... 1
J. Fine Adjustment Bracket ..................... 1
K. T-Handle Hex Wrenches 4, 6, 8mm .... 1 Ea.
L. Compression Spring (Fence) ................. 1
Figure 1. Box 1 inventory.
C
B
D
A
To Next Page
Need help?
General