Woodstock SHOP FOX W1872 User Manual (English)

Questions and Answers:

R
Ryan CookJul 29, 2025
What to do if my Woodstock SHOP FOX W1872 does not start?
- C
  Christopher SmithJul 29, 2025
  If your Woodstock Saw doesn't start, or the fuse/breaker trips right away, there could be several reasons. First, the variable-speed potentiometer might be faulty and needs testing or repair. Second, check if the switch disabling key is removed; if so, install it. Third, the power supply circuit breaker might have tripped, or the fuse blown, so ensure the circuit is correctly sized and free of shorts, then reset the breaker or replace the fuse. Fourth, the power supply voltage or circuit size could be incorrect, so verify they are correct. A faulty circuit board or motor could also be the reason, requiring inspection or replacement/repair.
T
Tara GibsonAug 4, 2025
Why does my Woodstock SHOP FOX W1872 Saw stall?
- D
  Derek VelasquezAug 4, 2025
  If your Woodstock Saw stalls or seems underpowered, several factors could be at play. A blown fuse could be the culprit; replace it and ensure there are no shorts. The workpiece material may be incorrect, so inspect and replace it if needed. If the feed rate or cutting speed is too fast, try decreasing them. The machine might be undersized for the task, so use the correct blade and reduce the feed rate or depth of cut. Also, check the motor brushes for faults and replace them if necessary. Finally, the motor may have overheated; let it cool down and reduce the workload.
C
Colleen LutzAug 10, 2025
How to prevent excessive blade breakage on my Woodstock SHOP FOX W1872?
- A
  Adam RichardsonAug 11, 2025
  Excessive blade breakage in your Woodstock Saw can occur for several reasons. The blade might not be tensioned correctly. Also, if you're cutting tight curves without using enough relief cuts, or if you're twisting the blade, this can cause breakage; use more relief cuts for tight turns, reduce the feed rate, and let the blade do the work without twisting it. Ensure you're using the correct blade for the operation. Too much pressure on the blade can also lead to breakage, so reduce the pressure on the workpiece as it passes through the blade. Finally, double-check that you've selected the correct blade for the cutting task.
C
cflowersAug 17, 2025
Why is my Woodstock SHOP FOX W1872 Saw vibrating?
- L
  Lisa FergusonAug 17, 2025
  If your Woodstock Saw is vibrating or operating noisily, check for a few potential causes. A motor or component might be loose; replace any damaged or missing bolts/nuts, or simply tighten them if they're loose. The blade itself could be at fault, so replace a warped or bent blade. If the machine is incorrectly mounted to the workbench, tighten the mounting hardware. Lastly, a loose or broken motor mount could be the source of the problem; tighten or replace it.
T
Travis WallaceAug 23, 2025
What to do if the blade won't stay on the layout line on my Woodstock SHOP FOX W1872 Saw?
- G
  gregoryowensAug 23, 2025
  If the blade of your Woodstock Saw won't stay on the layout line, it could be due to a few reasons. The blade might not be tensioned correctly. Also, too much pressure applied to the workpiece can cause the blade to wander; reduce the feed rate and pressure on the workpiece. Finally, the blade holders might not be aligned correctly; re-adjust them so they are aligned in a straight line with the saw.