14 / 21
Closing / opening a GPIO port through OSC
1º-In the control device adjust the IP target according to the IP of the LM GPIO.
2º-In the control device adjust the port as 9000
3º-From the control device we send the command:
/gpio1/mode
With a value “1” to configure the GPIO as output.
4º-From the control device we send the command:
/gpio1/value
With a value “1” to activate GPIO 1 port
5º- From the control device we send the command:
/gpio1/value
With a value “0” to deactivate GPIO 1 port
To Next Page
Loading...
