Work Pro Light Mouse Series - Page 18

18 / 21
Close several GPIO ports of a remote LM GPIO
1º-Connect both LM-GPIO´s to the network and using WorkCAD we add them to a project.
2º-Configure GPIO1 as input local device
3º- Configure GPIO2, GPIO3, GPIO4 as output remote device
4º-In “Commands” section select “Bank” GPIO1
5º-In “Event” select “On Activate”
Where:
-IP to enter IP address of the remote device that we want to send the message.
- Port to enter the destiny port of the message (9000 in this case)
6º-In Command enter the command:
//gpio2/value;,i;1;
7º-“click” on “Add” button
8º- “click” on “Apply” button to store changes.
//gpio3/value;,i;1;
9º-“click” on “Add” button
10º- “click” on “Apply” button to store changes.
//gpio4/value;,i;1;
11º-“click” on “Add” button
12º- “click” on “Apply” button to store changes.
Now when the GPIO1 port ( GND+Pin1) from local LM is deactivated, the GPIO2, GPIO3 &
GPIO4 from remote LM GPIO will active