19 / 21
Activate several ports when the device starts
1º-Connect the LM-GPIO to the network and using WorkCAD we add it to a project.
2º-Configure GPIO1 as output
3º- Configure GPIO2 as output
4º-In “Commands” section select the “On Start” Bank
5º-In IP enter: 127.0.0.1
6º-In Port enter: 9000
7º-In Command enter the command:
//gpio2/value;,i;1;
8º-“click” on “Add” button
9º- “click” on “Apply” button to store changes.
//gpio1/value;,i;1;
10º-“click” on “Add” button
11º- “click” on “Apply” button to store changes.
Now, when LM-GPIO starts, the GPIO2 and GPIO1 will be activated.
To Next Page
Loading...
