Series 4500
MOBILE TABLE
WITH SWAYBRACE
ASSEMBLY INSTRUCTIONS
For Job No.:
Assembly Tips
• Do not remove components from cartons prior to assembly, as
components do not bear part numbers. Use packing list to locate each
component by the carton number.
•Sort hardware kits by number. Do not open bags until ready for use.
•Assemble basic unit rst, then add any optional accessories.
Kit #21
4 ea. - 5/16-18 x 3/4" Hex Head
Cap Screws
4 ea. - 5/16" Flat Washers
Kit #38
16 ea. - 5/16-18 x 3/4" Hex Head Cap
Screws
16 ea. - 5/16-18 Serrated Flange Nuts
Kit #81
8 ea. - 5/16-18 x 3/4" Hex Head Cap
Screws
8 ea. - 5/16" Lock Washers
8 ea. - 5/16" Flat Washers
Kit #84
4 ea. - Flat Clips
2 ea. - Z Clips
2 ea. - 1/4" Flat Washers
6 ea. - 1/4-20 x 3/4" Round Head
Machine Screws
3
Lit #400-07A (Rev 08/2012)
MODULAR BENCH SYSTEMS
®
WORKPLACE SYSTEMS, INC.
562 Mammoth Rd • Londonderry, NH 03053
Call 800-258-9700 •Fax 603-622-0174
INSTALLING THE WORKSURFACE
Important Note: Install any optional "Type A" accessories prior to mounting Top.
(See attached instruction sheets to install optional accessories.)
If unit is equipped with a Conductive Top: See enclosed sheet for additional
information regarding conductive tops.
(Kit #84) Position TOP on
completed assembly, with rear
edge ush with rear of Frame, and
centered over each end. Note: Top
will overhang 2" at each end and 1"
at front
.
Pre-installed metal inserts are
located on underside of Top for
ease in fastening. Secure Top to
Frame with fasteners from Kit #84,
noting that at clips are used at
each end, while "Z" clips are used
at center.
1
FLAT CLIP
Z-CLIP
CONTENTS OF HARDWARE KITS
To Next Page
Need help?
General