Workrite Ergonomics Sierra Series User Manual

#1500152-Rev B Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Sierra Series Workcenters - Special Settings
Adjust Starting Digital Height Readout
(If you have a worksurface that is not 1⅛" thick, causing the lowest height readout to be incorrect)
Lower the table to the lowest position and measure the height from the oor to the top of the
worksurface. (not shown)
Press the “SET” button with a ballpoint pen (NOT paperclip).
Press and hold “Down” button until display ashes.
Press “Up” or “Down” button until display shows actual height for the worksurface.
Press the “SET” button with a ballpoint pen (NOT paperclip).
Note: Height readout must be readjusted separately for inches and centimeters.
Table Locking Feature
To Lock:
Press and hold the “SET” button with a ballpoint pen until the control box clicks two times –
The table will now be locked and will not move when any buttons are pushed. A padlock icon will
appear on the display when the table is locked.
To Unlock:
Press 1, then 2 and then 3 to unlock. *The default unlock code is always 1-2-3.
a
b
or
+
2
3
1
5
10
15
20
25
3035
40
45
50
55
60
b
a
b
c
d
e
or
+
2
3
1
5
10
15
20
25
3035
40
45
50
55
60
b c
d
e
a

Workrite Ergonomics Sierra Series Specifications

General

Brand	Workrite Ergonomics
Model	Sierra Series
Category	Indoor Furnishing
Language	English