Workrite Ergonomics Sierra Series User Manual

Workrite Ergonomics | 800.959.9675 www.workriteergo.com #1500152-Rev B
Sierra Series Workcenters - Special Settings
Set Custom Height Limits
You can set custom limits for both the upper and lower height range.
A custom upper height limit must be higher than 35” and the custom lower height range must be
below 35”.
You can set just an upper or lower custom height limit - it is not necessary to set both an upper
and a lower height limit.
To set or delete a new lower limit:
Move to the desired lower limit anywhere lower than 35 inches
Press the following buttons at the same time for about 4 seconds:
Button 1, Button 2 and the Up Arrow
If the code “S 4” appears release all Buttons and then press Button 1 to set this custom lower limit
or Button 2 to delete this custom lower limit
OR
If any other code appears in the display, release the buttons and then press either the Up or the
Down button until the display reads “S 4” and then press Button 1 to set this custom lower limit or
Button 2 to delete this custom lower limit
To set or delete a new upper limit:
Move to the desired upper limit anywhere higher than 35 inches
Press the following buttons at the same time for about 4 seconds:
Button 1, Button 2 and the Up Arrow
If the code “S 4” appears release all Buttons and then press Button 1 to set this custom upper limit
or Button 2 to delete this custom upper limit
OR
If any other code appears in the display, release the buttons and then press either the Up or the
Down button until the display reads “S 4” and then press Button 1 to set this custom upper limit or
Button 2 to delete this custom upper limit
a
b
c
or
+
2
3
1
5
10
15
20
25
3035
40
45
50
55
60
b
a
b
c

Workrite Ergonomics Sierra Series Specifications

General

Brand	Workrite Ergonomics
Model	Sierra Series
Category	Indoor Furnishing
Language	English