Workzone 937 - General Safety Information; Risk of Explosion and Fire; Risk of Chemical Burns

Cleaning Technical data
14 15
Cleaning
PLEASE NOTE!
Risk of damage!
Incorrect handling of the work light may potentially damage it.
− Do not use aggressive cleaning agents, brushes with metal or
nylon bristles and also not sharp or metallic cleaning objects
such as knives, hard spatulas or similar objects. These can
damage the surface.
− Do not immerse the work light, the USB charging cable or the
USB power adaptor in water in order to clean them and never
under any circumstances put them in a dishwasher.
− Do not clean the work light or the USB charging cable under
running water or spray them with a garden hose or a pressure
washer.
− Remove dust and dirt from the work light with a soft, slightly dampened cloth.
− For stubborn dirt, use a mild detergent if necessary.
Storage
− Before storing the work light away, fully charge the battery
(see section headed “Charging the work light”).
− Always store the work light in a dry place where it is protected from direct
sunlight and inaccessible to children.
Technical data
Work light
Model: 937
Article no.: 803119
Material: Casing: Plastic
Carry handle: Plastic
Size: 170 x 125 x 45 mm
Weight: 485 g
Input voltage: 5V
Protection class: III
Light source: COB-LED chip, permanently installed
LED output: 10W
Light current: 800 lm (100 % brightness)
400 lm (50 % brightness)
Service life: 50000 h
Max. projection area: 16 cm
2
Battery type: Li-Ion, 4400mAh
Risk group
(according to EN 62471:2008): 1
Protection class: IP 54 – Protected against ingress of dust
and splashwater
Minimum distance
to illuminated objects: 10cm
Power bank output voltage: 5 V, 1A