Troubleshooting 8
WARNING
Do not make any attempt to repair the machine yourself. You can put your
life at risk through electrocution, and this can cause damage to the machine
and invalidate your warranty.
The table below is a useful point of reference if malfunctions occur.
Troubleshooting table
Fault Cause Solution
Not functioning
- Power supply
interrupted
- Machine switched off
- Defective components,
e.g. switches, motor
- Check the power connection,
cord and fuse; if necessary, have
them repaired by an electrician
- Activate the ON/OFF switch
- Consult Customer Service
Machine works
with interruptions
- Power cord damaged
- Internal electrical
connection has
comeloose
- ON/OFF switch
defective
- Consult Customer Service
No or minimal
build-up of
pressure
- Air in the system, needs
to be vented
- Operate the machine without the
high-pressure hose connected
until the water emerges clear of
bubbles. Attach the hose again.
- No or inadequate water
intake
- Check / open the intake valve
- Check the intake hose for leaks or
blockages
- Clogged dirt filter - Check and clean the filter
- Spray lance set to low
pressure
- Check the spray lance setting
- Machine draws in air - Check the intake hose for leaks
• Place the protective cap onto the threaded connector in order to avoid dirt and
damage.
• Wind the power cord onto the cord bracket (4).
• Secure the end of the cord with the cord clamp, as shown in figure.
If the machine is not going to be used for a lengthy period of time, empty the
detergent tank and drain the water out of the hoses.
Store the machine upright in a dry, frost-free, well ventilated place, out of the reach
ofchildren.
Transport
Where possible, use the original packaging for transport.
To Next Page
Loading...
Need help?
General
