19
d
1300 922 271
service.australia@einhell.comAFTER SALES SUPPORT
4
Instructions for use
The table saw is designed for the slitting and cross-cutting (only with the
cross stop) of all types of timber commensurate with the machine‘s size.
The machine is not to be used for cutting any type of round wood.
The equipment is allowed to be used only for its intended purpose. Any
other use is deemed to be a case of misuse. The user/operator and not
the manufacturer will be liable for any damage or injuries of any kind
resulting from such misuse.
Please note that our equipment has not been designed for use in
commercial, trade or industrial applications. Our warranty will be voided
if the equipment is used in commercial, trade or industrial businesses or
for equivalent purposes.
The equipment is to be operated only with suitable saw blades (saw
blades made of HM or CV) It is prohibited to use any type of HSS saw
blade and cutting-off wheel. Intended use also includes complying with
the safety information, the assembly instructions and the operating
instructions contained in the operating manual.
All persons who use and service the equipment have to be acquainted
with these operating instructions and must be informed about the
equipment‘s potential hazards. It is also imperative to observe the
accident prevention regulations in force in your area. The same applies
for the general rules of health and safety at work.
The manufacturer will not be liable for any changes made to the
equipment nor for any damage resulting from such changes.
WZTS_1701_AUS_SPK7.indb 19 06.05.13 11:17
To Next Page
Loading...
