What to do if my Workzone Saw motor is not running?
If the motor of your Workzone Saw isn't running, first, use a lamp to check if the socket has power. Then, inspect the mains cord and any extension cords for damage, as a triggered house fuse or fault current protection switch could be the cause. Also, the motor overload protection might have been activated; in that case, let the saw cool off for at least 15â20 minutes.
Why does my Workzone Saw have insufficient cutting power and produce a large amount of dust?
If your Workzone Saw has insufficient cutting power, doesn't run smoothly, and produces a large amount of dust, it's likely that the saw blade is dull or defective. The solution is to replace the saw blade.
What to do if my Workzone Saw motor produces a large amount of sparks?
If the motor of your Workzone Saw is producing a large amount of sparks, this indicates that the carbon brushes are defective. Have the table saw checked by a qualified workshop.
Explains symbols used in the manual and on the machine for safety and information.
Defines intended use, general safety guidelines for power tools, workplace, and electrical precautions.
Covers personal protective equipment, safe posture, and precautions when handling the power tool.
Focuses on safe operation, noise reduction, and safe handling of saw blades.
Guide to unpack and verify all parts of the table saw and accessories are present and undamaged.
Step-by-step instructions for assembling the main support structure of the table saw.
Instructions for attaching table extensions and the parallel guide for setup.
Steps to prepare the saw, including changing the blade and folding the protective hood.
Guide to setting cutting depth, angle, parallel guide, and cross guide for accurate cuts.
Step-by-step guide for performing lengthwise cuts, narrow workpiece cuts, and bevel cuts safely.
Section for recording user and product details for warranty claims.
Outlines the terms, coverage, exclusions, and claim process for the product warranty.
To Next Page
General
