Residual risks:
Despite being used properly, certain residual risk factors cannot be
completely ruled out. The following risks associated with the design
and construction of the machine may apply:
− Contact with the part of the saw blade that is not covered
− Reaching into the rotating saw blade (cut injury)
− Kickback of workpieces and parts of workpieces
− Saw blade breaks
− Projection of defective hard metal parts of the saw blade
− Hearing loss in the event of failure to use the required ear protection
− Emission of wood dust that is harmful to health if used in en-
closed spaces
First use
Checking the table saw and product contents
1. Carefully take the table saw out of the packaging.
2. Check to make sure that the delivery is complete (see fig. A).
3. Check whether the table saw or the accessories exhibit damage.
4. In the event of damages or missing parts, do not use the table saw. Contact the
manufacturer via the service address indicated on the warranty card.
Assembly
WARNING!
Before start-up, assemble the table saw properly and completely,
including all covers and safety devices.
− Only once you have completed assembly, may you insert the
mains plug in the socket.
You will need the following tools for assembly:
• two AF 10 ring spanners
• one ring and one AF 8 open-ended spanner
• one 4 mm Allen wrench
• PH2 star-headed screwdriver
To Next Page
Loading...
Need help?
General
