Adjusting the scale on the cross guide
For this work, you will need an AF 7 spanner and a PH2 star-headed screwdriver.
1. Screw the stop rail
14
onto the cross guide
19
as previously described.
2. Place a 90° stop angle on the saw blade.
3. Loosen the knurled screw
51
of the
cross guide.
4. Use the 90° angle bracket to align the stop
rail exactly with the saw blade.
5. Tighten the knurled screw again.
6. Check whether the cross guide indicates
exactly 0°. If this is not the case, adjust the
scale as follows:
7. Loosen the two domed cap nuts
52
by
turning them a few revolutions. If the screws
are also turning, you can hold them in place
from below with a star-headed screwdriver.
8. Set the scale to the correct position.
9. Tighten the two domed cap nuts again.
The laser
You can use the laser to perform precision cuts with your circular saw.
The laser light is produced by a laser diode that is powered by two batteries
(1.5V AA/LR03). The laser light is widened into one line and is emitted through the
laser light opening. You can use the line as an optical mark for the cutting line when
performing a precision cut. Observe the laser safety notes.
− Switching the laser on: Set the laser switch
35
to “I”. The laser switch can be
accessed through the opening on the top side if the protective hood is mounted.
A red laser beam will now be emitted out of the laser light opening. Keeping the
laser beam along the cutting line mark while sawing will ensure that your cuts
are neat.
− Switching the laser off: Sett the laser switch
35
to “0”. The laser beam will go out.
To save the battery power, always switch the laser off when it is no longer needed.
Dust and chips that have accumulated may block the laser beam. You should there-
fore remove these particles from the protective hood after every use.
51
52
To Next Page
Loading...
Need help?
General
