38
d
1300 922 271
service.australia@einhell.comAFTER SALES SUPPORT
6.10.1.2 Cutting very narrow workpieces (Fig. 41)
• Be sure to use a push block when making longitudinal cuts in very
narrow workpieces with a width of 30 mm and less.
• The low guide face of the parallel stop is best used in this case.
• There is no push block supplied with the saw! (Available from your
specialist dealer)
• Replace the push block without delay when it becomes worn.
39 40
41
1
2
45
7
17
WZTS_1701_AUS_SPK7.indb 38 06.05.13 11:19
To Next Page
Loading...
