Worx Nitro WG752.X Series

Questions and Answers

R
Ryan BrownAug 17, 2025
What to do if Worx Nitro Lawn Mower doesn’t run when operating bail is activated?
- S
  Shelby SawyerAug 17, 2025
  If your Worx Nitro Lawn Mower doesn’t run when the operating bail is activated: Release the operating bail to turn the mower off. Remove the batteries. Turn the mower over and check that the blade is free to turn. If it's not free, contact customer service. Ensure the mower isn't sitting in tall grass, which can prevent the blade from starting. If so, move it to an area where it isn't under load to start.
M
Mitchell CastilloAug 19, 2025
Why does my Worx Nitro WG752.X motor stop while mowing?
- A
  Amy Robinson MDAug 19, 2025
  If the motor of your Worx Nitro Lawn Mower stops while mowing, the battery may not be fully charged. Plug in the charger and wait for the green light to come on, indicating a full charge.
C
Carl LarsenAug 22, 2025
Why is my Worx Nitro WG752.X Lawn Mower battery charger LED not on?
- K
  Kelly MoranAug 22, 2025
  If the battery charger LED on your Worx Nitro Lawn Mower is not on: - Check the plug connection to ensure it is properly connected. - If the connection is fine, the charger may need to be replaced.
J
Jeanne MorrisonAug 25, 2025
What to do if Worx Nitro WG752.X is abnormally noisy and vibrates?
- K
  kmorganAug 26, 2025
  If your Worx Nitro Lawn Mower is abnormally noisy and vibrates: - Release the operating bail to turn the mower off and remove the batteries. - Turn the mower on its side and check the blade to ensure it hasn't been bent or damaged. If the blade is damaged, replace it. - If the underside of the deck is damaged, call customer service. - If there is no visible damage to the blade and the mower still vibrates: Release operating bail to turn mower off, Remove batteries and remove blade. Rotate blade 180 degrees and retighten. If mower still vibrates, contact customer service.
A
Anthony KleinAug 28, 2025
What to do if Worx Nitro Lawn Mower cutting performance is unsatisfactory?
- J
  Jill NewtonAug 28, 2025
  If the cutting performance of your Worx Nitro Lawn Mower is unsatisfactory: - Ensure the battery has been fully charged by plugging in the charger and waiting for the green light. - Turn the mower off, remove the batteries, and check the blade for sharpness and the deck/discharge chute for clogging. Keep the blade sharp. - The wheel height adjustment may be set too low for the grass condition. Try raising the cutting height.
D
Deanna TuckerAug 30, 2025
What to do if Worx Nitro WG752.X is not picking up clippings?
- J
  Justin MooreAug 30, 2025
  If your Worx Nitro Lawn Mower is not picking up clippings with the grass collection bag: - Check for a clogged chute. Turn the mower off, remove the batteries, and clear any grass clippings from the chute. - If too much cut grass is clogging the airflow, raise the cutting height of the wheels to shorten the length of the cut. - The bag might be full, so try emptying it more often.
L
lucasjesseSep 2, 2025
How to fix Worx Nitro Lawn Mower that is too hard to push?
- C
  christinejonesSep 2, 2025
  If your Worx Nitro Lawn Mower is too hard to push: - Raise the cutting height to reduce deck drag on the grass. - Check each wheel for free rotation.
D
dennisshawnSep 5, 2025
Why is Worx Nitro WG752.X battery charger LED not turning green?
- C
  Christopher LeSep 5, 2025
  If the battery charger LED on your Worx Nitro Lawn Mower does not flip to green, the battery needs to be diagnosed. Contact customer service.
W
William StevensSep 8, 2025
Why are there clippings visible when mulching with Worx Nitro Lawn Mower?
- J
  Jennifer BennettSep 8, 2025
  If there are clippings visible when mulching with your Worx Nitro Lawn Mower: - There might be too much cut grass. Raise the cutting height of the wheels to shorten the length of the cut. Avoid cutting off more than 1/3 of the total length. - Check the blade for sharpness, and ensure you always keep it sharp.
A
Angela MurphySep 12, 2025
Why is my Worx Nitro WG752.X run-time low after uses?
- R
  Richard WilkinsonSep 12, 2025
  If you experience low or diminished run-time after many uses of your Worx Nitro Lawn Mower, contact customer service. A new battery may be required.

Summary

1. SAFETY INSTRUCTIONS

I. GENERAL OPERATION

II. SLOPE OPERATION

III. CHILDREN

IV. SERVICE

GENERAL SERVICE

Maintenance and repair procedures for the lawn mower.

Safe operation practices for walk-behind mowers

2. COMPONENT LIST

3. TECHNICAL DATA

SUGGESTED BATTERIES AND CHARGERS

4. INTENDED USE

5. ASSEMBLY & OPERATION

Handle Assembly

Steps for assembling and adjusting the lawn mower handle.

Grass Bag Assembly and Removal

Instructions for attaching and emptying the grass collection bag.

Battery Pack Installation and Charging

Procedures for installing, removing, and charging the battery pack.

Starting and Stopping the Mower

How to safely start and stop the cordless lawn mower.

MULCHING MOWING TIPS

CUTTING AREA TIPS

6. MAINTENANCE

BLADE SHARPENING

Instructions for sharpening the lawn mower blade.

BLADE BALANCING

Procedure for balancing the lawn mower blade.

BLADE MAINTENANCE

Information on replacing the lawn mower blade.

7. STORAGE

8. TROUBLE SHOOTING

Mower Doesnt Run

Solutions for when the mower does not run when the operating bail is activated.

Motor Stops While Mowing

Troubleshooting steps when the motor stops during operation.

Unsatisfactory Cutting Performance

Addressing issues with poor cutting performance or incomplete mowing.

Mower Too Hard to Push

Solutions for a mower that is difficult to push.

Abnormal Noise and Vibration

Troubleshooting excessive noise and vibration from the mower.

Battery Charger LED Issues

Resolving problems with battery charger indicator lights.

Mower Not Picking Up Clippings

Solutions for when the grass collection bag is not filling.

Worx Nitro WG752.X Series Specifications

General

Voltage	40V
Battery Type	Lithium-Ion
Drive System	Self-Propelled
Mulching Capability	Yes
Bagging Capability	Yes
Side Discharge	Yes
Number of Batteries Included	2
Battery Amp Hour	4.0 Ah
Power Source	Battery
Cutting Width	21 in
Weight	28 kg
Grass Collection Capacity	60 L
Warranty	3 years