Worx Sonicrafter WX696 - Page 9

9
20V Cordless Oscillating Tool EN
- - -
- - -
=
LED light is a battery capacity in-
dicator and will flash when power
gets low.
COMPONENT LIST
1. ON/OFF SWITCH
2.
BATTERY PACK*
3. VARIABLE SPEED DIAL
4.
UNIVERSAL-FIT ACCESSORY INTERFACE**
5. LED LIGHT
6. FLANGE
7. ONBOARD HEX WRENCH
*Not all the accessories illustrated or de-
scribed are included in standard delivery.
**Works with other oscillating tool brands’ acces-
sories.
The following brands are trademarks owned by third
parties which may be registered by their respective
owners:
Black & Decker
®
, Bosch
®
, Chicago Electric
®
,
Craftsman
®
, Dremel
®
, DeWalt
®
, Fein
®
, Genesis
®
,
Imperial Blades, Makita
®
, Mastercraft
®
,
Milwaukee
®
, Performax
®
, Porter Cable
®
, Ridgid
®
,
Ryobi®, Skil
®
, Rockwell
®
and Tool Shop
®
.
TECHNICAL DATA
Type Designation WX696 WX696.X
(6-designation of machinery, representative of
Oscillating Tool)
WX696 WX696.X****
Voltage 20 V
Max***
Oscillations speed 5000 - 18000 /min
Oscillating angle 3.6°
Machine weight (Bare tool) 0.9 kg
***Voltage measured without workload. Initial
battery voltage reaches maximum of 20 volts.
Nominal voltage is 18 volts.
****X=1-999, A-Z, M1-M9 there are only used for
different customers, there are no safe relevant
changes between these models
Category Type Capacity
20V Battery WA3550 1.5Ah
WA3550.1 1.5Ah
WA3551 2.0Ah
WA3551.1 2.0Ah
WA3553 4.0Ah
20V Charger WA3760 0.4A
WA3869 2.0A
WA3880 2.0A
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
NOISE INFORMATION
A weighted sound pressure L
pA
: 73.0dB(A)
A weighted sound power L
wA
: 84.0dB(A)
K
pA
& K
wA
3 dB(A)
Wear ear protection.
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined
according to EN 62841:
Vibration emission value:
a
h
= 2.805m/s
2
Uncertainty K = 1.5m/s²
The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a
preliminary assessment of exposure.
WARNING: The vibration and noise
emissions during actual use of the power tool
can differ from the declared value depending on the
ways in which the tool is used especially what kind of
workpiece is processed dependant on the following
examples and other variations on how the tool is
used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well
maintained.