IMPORTANT SAFETY
INSTRUCTIONS
Save these instructions - this manual
contains important safety and operating
instruction for battery charger models
WA3724 .
DANGER – To reduce the risk of fire or
electric shock, carefully follow these
instructions
Before using battery charger, read all
instructions and cautionary markings on
battery charger, battery, and product using
battery.
WARNING:
1. WARNING – To reduce the risk of
fire and electric shock, install in a
temperature- and humidity-controlled
indoor area relatively free of conductive
contaminants.
2. CAUTION – To reduce the risk of fire and
electric shock, remove battery charger
from the receptacle when not in use.
3. WARNING –To Avoid Electric Shock
–Do not touch exposed live terminals
or connected parts.
4. CAUTION – For use indoor only. To
reduce the risk of fire and electric shock,
do not expose to liquid, vapor, or rain.
5. CAUTION–To reduce risk of injury,
charge only WA3229 (for WG770) /
WA3220 (for WG788/WG789) type
rechargeable batteries. Other types of
batteries may burst causing personal
injury and damage.
6. Working in the vicinity of a lead-acid
battery is dangerous. Batteries generate
explosive gases during normal battery
operation. For this reason it is of the
utmost importance that each time before
using your charger, you read and follow
the instructions provided exactly.
7. To reduce risk of battery explosion, follow
these instructions and those marked on
the battery.
8. Never smoke or allow an open spark
or flame in the vicinity of the battery or
engine.
9. Use charger for charging a lead-acid
battery only. It is not intended to supply
power to an extra-low-voltage electrical
system or to charge dry-cell batteries.
Charging dry-cell batteries may cause
them to burst and cause injury to persons
and damage to property.
10. Never charge a frozen battery.
11. study all battery manufacturer’s specific
precautions such as removing or not
removing cell caps while charging and
recommended rates of charge.
12. Never place the charger directly above or
below the battery being charged; gases
or fluids from the battery will corrode and
damage the charger. Locate the charger
as far away from the battery as dc cables
permit.
13. Do not operate charger in a closed-in area
or restrict ventilation in any way.
14. Connect and disconnect dc output clips
only after setting any charger switches
to the off position and removing ac cord
from the electric outlet. Never allow clips
to touch each other.
Save these instructions
To Next Page
Loading...
Need help?
General
