Dual Port Battery Charger EN
3
PRODUCT SAFETY
SAFETY INSTRUCTIONS
WARNING: This product can expose you
to chemicals including lead and Di(2-
ethylhexyl)phthalate (DEHP) which are known
to the State of California to cause cancer and
birth defects or other reproductive harm. For
more information go to www.P65Warnings.
ca.gov.
Information for radiated emission
This device complies with Canadian ICES-001.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
WARNING: Changes or modifications to
this unit not expressly approved by the party
responsible for compliance could void the user’s
authority to operate the equipment.
- NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
SYMBOLS
Before charging, read the instruction
manual
Warning
Double insulation
1. CHARGER
2. CHARGE INDICATOR LIGHTS
3. BATTERY PACKS*
*Not all the accessories illustrated or
described are included in standard delivery.
TECHNICAL DATA
Rated Input voltage 120V~60Hz
Output voltage 20V
Charging current 2A
Rated Input power 50W
Charge battery Li-Ion
Charging time (approx.)
Battery pack 2.0 Ah (1pc) Approx. 65min
2.0 Ah (2pcs) Approx. 130min
2.5 Ah (1pc) Approx. 80min
2.5 Ah (2pcs) Approx. 160min
4.0Ah (1pc) Approx. 130min
4.0Ah (2pcs) Approx. 260min
Protection class
/II
Machine weight 0.53 kg
For the technical data of the types, the number of
cells and the rated capacity of the batteries that can
be charged, please refer the nameplate of the battery
pack supplied by Worx.
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
To Next Page
Loading...
