Battery Charger EN
6
between 18
o
C and 24
o
C.
Do not charge the battery
pack in air temperatures
below 4.5
o
C, or above
40.5
o
C. This is important
as it can prevent serious
damage to the battery
pack.
17.Charge only battery
pack of the same model
provided by Worx and of
models recommended by
Worx .
SYMBOLS
CHARGING PROCEDURE
NOTE: Before using the tool, read the
instruction book carefully.
CHARGING INSTRUCTIONS
1. CHARGING YOUR BATTERY PACK
WARNING: The charger and battery pack are
specifically designed to work together so do
not attempt to use any other devices. Never insert
or allow metallic objects into your charger or battery
pack connections because an electrical failure and
hazard will occur.
2. BEFORE USING YOUR CORDLESS TOOL
Your battery pack is UNCHARGED and you must
charge once before use.
3. HOW TO CHARGE YOUR BATTERY
CHARGING PROCEDURE
1) Plug the charger into an appropriate outlet.
2) Slide the battery pack into the charger. The
LIGHT (3) will become green and flash to show
charging has started.
3) After charging15min(1.3Ah) / 17min(1.5Ah) /
25min(2.0Ah) / 38min(3.0Ah) / 45min( 4.0Ah) /
70min(6.0Ah), the light will stay green without
flashing, which means the battery is full, and
charging is completed.
WARNING: When battery charge runs
out after continuous use or exposure
to direct sunlight or heat, allow time for the
battery to cool down before re-charging to
achieve the full charge.
CHARGING INDICATOR
This charger is designed to detect some problems
that can arise with battery packs. Indicator lights
indicate problems (see table below). If this occurs,
insert a new battery pack to determine if the charger
is OK. If the new battery charges correctly, then the
original pack is defective and should be returned
to a service center or recycling service center. If the
new battery pack displays the same problem as the
original Battery Pack, have the charger tested at an
authorized service center.
Light ON/ Flash Status
Red on
Defective Battery
Read the operator’s manual
Warning
For indoor use only
Double insulation
Fuse
Positive terminal
Negative terminal
Waste electrical products must not be
disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or
retailer for recycling advice.
To Next Page
Loading...
