Patio-Brush EN
1110
18.
METAL HARD NYLON JOINT CLEANING BRUSH
(WA0293)
* Not all the accessories illustrated or described
are included in standard delivery.
TECHNICAL DATA
Type Designation WG441E WG441E.9 (441-
designation of machinery, representative of
Battery-operated brush)
WG441E WG441E.9
Rated voltage 20 V Max.**
Max. No-load
speed
700 /min
Water pressure 0.6 MPa
Rotational speed H700 /min; L500 /min
Machine weight 3.7 kg 2.9 kg
** Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal voltage
is 18 volts.
ACCESSORIES
Code WG441E WG441E.9
Battery pack WA3014 1 /
Charger WA3880 1 /
Soft nylon bristles-wood,
delicate and easily marked
surfaces like artificial turf
WA0290 / /
Hard nylon bristles -
General stone and hard
surfaces like brick, paving
stones, marble floor and
natural stone
WA0291 1 1
Hard nylon joint
cleaning brush-Mortar
joint cleaning for finished
stone surfaces
WA0292 / /
Metal / hard nylon joint
cleaning brush -Mortar
and sand joint cleaning for
bricks and block paving
WA0293 1 1
We recommend that you purchase your accessories
listed in the above list from the same store that sold you
the tool. Refer to the accessory packaging for further
details. Store personnel can assist you and offer advice.
NOISE INFORMATION
A weighted sound pressure L
pA
= 65.2 dB(A)
K
pA
3.0 dB(A)
A weighted sound power L
wA
= 78.61 dB(A)
K
wA
3.0 dB(A)
VIBRATION INFORMATION
Vibration emission value a
h
< 2.5 m/s
2
Uncertainty K = 1.5 m/s
OPERATION INSTRUCTIONS
NOTE: Read instruction handbook before
operation this machine.
INTENDED USE
The device is intended as a handhold cleaning and
maintenance device.
ASSEMBLY AND OPERATION
ACTION FIGURE
BEFORE OPERATION
Checking the battery charge condition
NOTE: Fig. A1 only applies for the battery
pack with battery indicator light.
See Fig. A1
Charging the battery pack
More details can be found in charger’s
manual
See Fig. A2
Installing the battery pack See Fig. A3
Removing the battery pack See Fig. A4
ASSEMBLY
Assembling the shaft See Fig. B
Assembling the auxiliary handle See Fig. C
Replacing the brush
NOTE: Choose a suitable brush according
to your work. See more details in the
ACCESSORIES section.
See Fig.
D1-D4
Using the hose retaining clip See Fig. E
To Next Page
Loading...
