12
WG441E WG441E.X
Patio-Brush
OPERATION INSTRUCTIONS
NOTE: Read instruction handbook before
operation this machine.
INTENDED USE
The device is intended as a handhold cleaning and
maintenance device.
ASSEMBLY AND OPERATION
ACTION FIGURE
BEFORE OPERATION
Checking the battery charge condition
NOTE: Fig. A1 only applies for the battery
pack with battery indicator light.
See Fig. A1
Charging the battery pack
More details can be found in charger’s
manual
See Fig. A2
Installing the battery pack See Fig. A3
Removing the battery pack See Fig. A4
ASSEMBLY
Assembling the shaft See Fig. B
Assembling the auxiliary handle See Fig. C
Replacing the brush
NOTE: Choose a suitable brush according
to your work. See more details in the
ACCESSORIES section.
See Fig.
D1-D4
Using the hose retaining clip See Fig. E
Attaching the garden hose to the brush
NOTE: After the garden hose is attached,
check the connection by gently pulling
upon the garden hose. It should not be
pulled off.
See Fig.
F1, F2
OPERATION
Starting
WARNING! Do not start or operate
the machine if others are in the
area! Never lift the device off the ground
during operation, as there is danger of
entanglement !
See Fig. G
Adjusting the speed See Fig. H
Water supply
WARNING! Do not connect the
machine to water supplies that
are dirty, rusty, muddy, or corrosive.
See Fig. I
Cleaning
WARNING: Make sure that the
surface to be cleaned is free from
debris e.g. stones, screws etc., which
could be flung up.
Never put your hands or feet near to the
rotating brushing equipment!
Cleaning with Soft nylon bristles See Fig. J1
Cleaning with Hard nylon bristles See Fig. J2
Cleaning with Hard nylon joint cleaning
brush
NOTE: Make sure the joint brush is
aligned with the centre of the joint by
using the joint alignment mark.
See Fig. J3
Cleaning with Metal / hard nylon joint
cleaning brush
See Fig. J4
MAINTENANCE
Check if the tool and the brush are in good condition
before use. Replace the brush if it wears down to a
diameter of ø approx. 90 mm.
Do not immerse the tool in water. Do not spray or clean
it with water. Protect he tool against moisture. Clean the
outside of the tool with a damp cloth or soft brush. Do not
use abrasives or harsh cleaning agents.
Clean the brush in water or with a strong water jet or a
hard brush.
Repairs must be carried out by a Worx service point.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not be disposed
of with household waste. Please recycle where
facilities exist. Check with your Local Authority or
retailer for recycling advice.
To Next Page
Loading...
